Under such circumstance, make sure this field is set to Auto or DDR System Error Message setting than indicated in Setup. The other code indicates that a DRAM error has occured. If the installation procedure in the installation guide differs from the one in this section, please follow the installation guide in the package. You must have two floppy drives to use this function.

Uploader: Meztilkis
Date Added: 15 August 2013
File Size: 52.16 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 16622
Price: Free* [*Free Regsitration Required]

DFI PSBL – motherboard – ATX – Socket – iG Overview – CNET

Remove the jumper caps from pins and pins of J7 prior to connecting the audio cable connector. If you selected an option other than the default setting and is unable to boot up the system, there are 2 methods of booting up the system and going back to its default setting. Connect the CPU fan to the 3-pin fan connector at location J13 of the system board. The default setting is Auto. The network will detect Magic Packet and assert a wakeup signal to power-up the system.

DFI PS35-BL – motherboard – ATX – Socket 478 – i865G

Your system supports five modes, 0 default to 4, which primarily differ in timing. This is to ensure an accurate diagnosis of the problem in case a problem has multiple causes.


Caution To avoid damage to the system: The parameters will automatically be shown on the screen.

Jumper Settings Hardware Installation 2. The DMI pool data is then verified or updated whenever the system hardware or setup is altered.

DFI PS35-BC User Manual

Check the path statement to make sure you are writing to the targeted drive. In a few cases, drives from two different manufacturers will not function properly when used together. You may be writing to the wrong drive. Reboot the system for the utility to take effect. You can regulate each volume to the speaker when playing digital sound sources.

The user will assume the entire risk of the use or the results of the use of this document.

The power switch of each peripheral device is turned on. You can enter up to 5 characters.

DFI PSBL A Motherboard Manual & User Guide – Fixya

Your version may not be identical to this one. System The system will not boot and access to Setup will be denied unless the correct password is entered at the prompt. Make sure the add-in card is seated securely in the expansion slot. Click the Performance tab. Make sure the colored stripe on the ribbon cable is aligned with pin 1 of connector J8. You must have two floppy drives to use this function. Enabling Hyper-Threading Technology c. This is where you will configure analog output settings to speakers.


To prevent improper floppy cable installation, the shrouded floppy disk header has a keying mechanism. Disabled Disables the onboard parallel port. Unlock ddfi socket by pushing the lever sideways, away from the socket, then lifting ps3 up to a 90o angle.

Move away any objects, such as another monitor or fan, that may be creating a magnetic field around the display. Although secondary monitors are supported, you do not have to select the type. Disabled The EPA logo will not appear during system boot-up.

The following message will appear. Joystick or MIDI port: Make sure there are no objects resting on the keyboard and that no keys are pressed during the booting process.

Award is a dfo trademark of Award Software, Inc.