The HiQV chipsets contain a multimedia engine that allow a 16bpp window to be overlayed on the screen. Using the PCI driver from that bundle causes scrambled video output. A general problem with the server that can manifested in many way such as drawing errors, wavy screens, etc is related to the programmable clock. Great proofreading, Asiliant, you goddamn wankers. The XVideo extension has only recently been added to the chips driver.

Uploader: Malahn
Date Added: 23 October 2011
File Size: 46.77 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 29925
Price: Free* [*Free Regsitration Required]

This manual is copyrighted by Chips andpermission of Chips and Technologies, Inc. Legal values are 2 to inclusive. You can use “Kermit” as well, but I haven’t tried it, so again doing that is at your own risk.

chips datasheet & applicatoin notes – Datasheet Archive

This can result in a reddish tint to 24bpp mode. Note that while you do not strictly need to use serial for this project, I did since the CD-ROM drive in my CDT doesn’t work, and, while opinions may differ quite a bit, it is also far more convenient than using a recordable CD.

The HiQV series of chips have three programmable clocks. Dual refresh rate display can be selected with the ” DualRefresh ” option described above.

The server doesn’t prevent the user from specifying a mode that will use this memory, it prints a warning on the console. It would be a good idea to perform the full format, so as to make sure there really are no bad sectors on the diskette. Page created on July 20, at 1: It may cause the driver selection window to disappear the first time, but it will now display all the options: In this way the expensive operation of reading back to contents of the screen is never performed and the performance is improved.


So for unexplained problems not addressed above, please try to alter the clock you are using slightly, say in steps of 0.

This driver must be considered work in progress, and those users wanting stability are encouraged to use the older XFree86 3. Using chipe option the mode can be centered in the screen. In this case enough memory needs to be left for the largest unscaled video window that will be displayed. Would anyone happen to have any advice or leads on the matter?

This chip is specially manufactured for Toshiba, and so documentation is not widely available. You will need to format the diskette, since that is also a requirement. So the value actually used for the memory clock might be significantly less than this maximum value. If you find you truly can’t achieve the mode you are after with the default clock limitations, look at the options ” DacSpeed ” and ” SetMClk “.

Information for Chips and Technologies Users

These option individually disable the features of the XAA acceleration code that the Chips and Technologies driver uses. Vcc33 mm Contact QQllb31 B powertip Next, insert your floppy diskette. For this reason a mode that is as close to VESA like as possible should be selected.


None of these are currently supported within the driver itself, so many cards will only have limited support. This is a very similar chip to the So this limit will be either 56MHz or chipa for the xx chipsets, depending on what voltage they are driven with, or 80MHz for the WinGine machines.

When transferring files, on the machine with the file, select “Send Chi;s, select which file you want to send one at a time! The Xserver assumes that the framebuffer, if used, will be at the top of video ram. Which diagnostic result should I believe, I wonder?

Worst case scenario, i wonder if i could load in a low profile graphics card that’s less trouble and get it to play ball with the internal LCD. However it additionally has the ability for mixed 5V and 3. This chip is similar to the but has a 64bit memory bus as opposed to a 32bit bus.

Try reducing the amount of memory consumed by the mode. Typically this is probed correctly, but if you believe it to be mis-probed, this option might help.